AN-405 NATIONAL Search Results

PAL29M16

Abstract: TXF2 AN-405
Contextual Info: AN-405 APPLICATION NOTE JT2F, CDB Devices, TXC-03702, -05105 Designing with TranSwitch JT2F and CDB Devices for Terminating ATM Applications at JT2 Data Rates Copyright 1995 TranSwitch Corporation TXC and TranSwitch are registered trademarks of TranSwitch Corporation

sensors mttf

Abstract: SAC405 UM 3841 4953 sac 405 "Hall Effect Sensor" mttf resistor activation energy sURVEY OF Hall Effect Current Measurements WLCSP Cu6Sn5
Contextual Info: Mean Time To Failure in Wafer Level-CSP Packages with SnPb and SnAgCu Solder Bumps Stephen Gee and Luu Nguyen National Semiconductor M/S 19-100 3875 Kifer Rd. Santa Clara, CA 95051 stephen.gee@nsc.com luu.nguyen@nsc.com ABSTRACT In this test setup, embedded die surface temperature sensors are

sac 405

Abstract: WLCSP flip chip IPACK2005 sensors mttf WLCSP chip mount SAC405 thetaja wlcsp "sac 405"
Contextual Info: The Effect of Electromigration on Eutectic SnPb and Pb-free Solders in Wafer Level-Chip Scale Packages Joanne Huang1, Stephen Gee2, Luu Nguyen2, King-Ning Tu1 1 Department of Materials Science and Engineering, University of California - Los Angeles, Los Angeles,

M4-05H

Abstract: MM506 M505H 504M
Contextual Info: NATIONAL M M 4 0 4 / M M 5 0 4 d u a l 16 b it s t a t ic re g iste r* M M 4 0 5 / M M 5 0 5 d u a l 3 2 b it s ta tic re g iste r* general description Additional features include: The National Semiconductor line of MOS static shift registers are monolithic integrated circuits

practical application of schmitt trigger

Abstract: CMOS ring oscillators RC phase shift oscillator AN-118 AN-90 C1995 MM54C00 MM54C02 MM54C04 AN-118 national
Contextual Info: National Semiconductor Application Note 118 Mike Watts October 1974 INTRODUCTION This note describes several square wave oscillators that can be built using CMOS logic elements These circuits offer the following advantages Y Guaranteed startability Y Relatively good stability with respect to power supply

74AS245

Abstract: 74AS04 DP8422 68020 74AS74 SA-47B 68020 74AS32 AN-539 C1995 DP8420A
Contextual Info: National Semiconductor Application Note 539 Joe Tate and Rusty Meier May 1989 INTRODUCTION This application note explains interfacing the DP8420A 21A 22A DRAM controller to the 68020 microprocessor Three different designs are shown and explained It is assumed that the reader is already familiar with

Contextual Info: International [tor Rectifier Data Sheet No. 1.032A SPA Series Microelectronic Power IC Relay 0.9 Amp Load Current 20 - 280 VAC rms CHIPSWITCH SIP RELAY SPA Series Features General Description The SPA Series ChipSwitch uses exclusive Inter­ national Rectifier S3X power integrated circuit technol­

74as04

Abstract: 74AS138 74as74 74as02 68450 TL E28 74AS245 AN-538 C1995 DP8420A
Contextual Info: National Semiconductor Application Note 538 Joe Tate and Rusty Meier May 1989 INTRODUCTION This application note explains interfacing the DP8420A 21A 22A DRAM controller to the 68000 Three different designs are shown and explained It is assumed that the reader is familiar with the 68000 access cycles and

74ls gate symbols

Abstract: 74LS DS34C86 RS-423 ST34C86 ST34C86CF16 ST34C86CP16 ST34C86IF16
Contextual Info: ST34C86 r v / l f l QUAD RS-422, RS-423 CMOS Diffsrsntisl LÌI16 RSCSiVGT .the analog plus company June 1997-3 FEATURES Pin-to-Pin Compatible with National DS34C86 Meets the EIA RS-422 Requirements Low Power CMOS Design Low Propagation Delays Three-State Outputs with Enable Pin

MN7000

Contextual Info: ASSEMBLY AND INSTALLATION INSTRUCTIONS R7000 10, 12, 15, 17, 20, 30, 40 Meters C O R P O R A T I O N 951465 10/96 R7000 WARNING THIS ANTENNA IS AN ELECTRICAL CONDUCTOR. CONTACT WITH POWER LINES CAN RESULT IN DEATH, OR SERIOUS INJURY. DO NOT INSTALL THIS ANTENNA WHERE THERE IS ANY POSSIBILITY OF CONTACT WITH HIGH VOLTAGE OR ARC-OVER FROM POWER CABLES

Contextual Info: 1N4933/L–1N4937/L Vishay Lite–On Power Semiconductor 1.0A Fast Recovery Rectifier Features D Diffused junction D Fast switching for high efficiency D High current capability and low forward A – 405 voltage drop D Surge overload rating to 30A peak D Low reverse leakage current

Contextual Info: 1N4933G/L–1N4937G/L Vishay Lite–On Power Semiconductor 1.0A Fast Recovery Glass Passivated Rectifier Features D D D D Glass passivated die construction Diffused Junction A – 405 Fast switching for high efficiency High current capability and low forward voltage

Comlinear Corporation

Abstract: CLC006 CLC006AJE GS9008 400Mbits
Contextual Info: Comlinear Serial Digital Cable Driver with Adjustable Outputs A National Semiconductor Company CLC006 APPLICATIONS: FEATURES: • Digital video routers, DAs, switchers • No external pull-down resistors required • 4fs c , 4:2:2 and 360Mbps serial digital video interfaces

rsw 434

Abstract: AN-1293 GM5WA06250 LP3936
Contextual Info: National Semiconductor Application Note 1293 Turo Piila March 2004 Introduction Timing and brightness of each output can be controlled separately, making color blending and different blinking sequences possible. A high current FLASH mode is also available.

3 pin 10K logic variable resistor

Abstract: 31-5329-72RFX CLC006 CLC006AJE CLC007 GS9008
Contextual Info: Serial Digital Cable Driver with Adjustable Outputs Comlinear A National Semiconductor Company CLC006 FEATURES: • No external pull-down resistors required • Two amplitude-adjustable outputs • 650ps rise and fall times • Operates from single +5V or -5.2V supply

PR1004

Abstract: PR1003 diode 15511 PR1001 PR1005 pr1004 diode
Contextual Info: PR1001/L–PR1005/L Vishay Lite–On Power Semiconductor 1.0A Fast Recovery Rectifier Features D Diffused junction D Fast switching for high efficiency D High current capability and low forward A – 405 voltage drop D Surge overload rating to 30A peak D Low reverse leakage current

Diode pr1007

Abstract: gl1004
Contextual Info: PR1001G/L–PR1007G/L Vishay Lite–On Power Semiconductor 1.0A Fast Recovery Glass Passivated Rectifier Features D D D D Glass passivated die construction Diffused junction A – 405 Fast switching for high efficiency High current capability and low forward

1N4004 LITEON

Abstract: diode LT 1n4007 1n4003 diode 1N4007 marking CD 1N4001 1N4002 1N4003 1N4004 1N4005 1N4006
Contextual Info: 1N4001G/L–1N4007G/L Vishay Lite–On Power Semiconductor 1.0A Glass Passivated Rectifier Features D Glass passivated die construction D Diffused junction D High current capability and low forward A – 405 voltage drop D Surge overload rating to 30A peak

Cord Products for Heavy Industry

Contextual Info: 8.5" Cord Products for Heavy Industry Cables for Heavy Industry, Mining, Petrochemical and Extreme Applications COVER 8.5" Super Vu-Tron III Types SJOOW/SOOW Carol 105°C 300 and 600 Volt UL/CSA Portable Cord 90°C 60 Applications Machine and power tools

AN-1291

Abstract: GM5WA06250 LP3933 gsw1
Contextual Info: National Semiconductor Application Note 1291 Turo Piila January 2004 Introduction Timing and brightness of each output can be controlled separately, making color blending and different blinking sequences possible. A high current FLASH mode is also available.

"Controller Area Network" DBC standard

Abstract: d-sub db9 777357 80386EX SJA1000 PXI-8461 80386EX CAN sja1000 pxi 8464 PCICAN TJA1054A
Contextual Info: Controller Area Network CAN Interfaces NI CAN Series 2 Interfaces for PCI, PXI, and PCMCIA • Hardware timing and synchronization with NI data acquisition, vision, and motion devices • 100% bus load; for up to 1 Mb/s • ISO 11898-compliant for standard

A4306SN

Contextual Info: ASSEMBLY AND INSTALLATION A4306SN 70 CENTIMETER BROADBAND 430-440 MHz SSB / CW / FM YAGI COMMUNICATIONS ANTENNAS 951703 6/96 A4306SN WARNING THIS ANTENNA IS AN ELECTRICAL CONDUCTOR. CONTACT WITH POWER LINES CAN RESULT IN DEATH OR SERIOUS INJURY. DO NOT INSTALL THIS ANTENNA WHERE THERE IS ANY POSSIBILITY OF CONTACT WITH OR HIGH VOLTAGE ARC-OVER FROM

H1012

Abstract: HX1148 H1338 H1019 H1042 H1086 H1089 H1117 H1138 HX1178
Contextual Info: 10/100 BASE-T SINGLE PORT TRANSFORMER MODULES With 1:1 Transmit Turns Ratios For RoHS part add suffix NL7 RoHS “NL” peak solder rating 260°C, non-RoHS peak solder rating 235°C°° Compatible with Broadcom, Intel, Micrel, National Semiconductor, ICS, and TDK Transceivers

51CM5

Abstract: A4S 29 RG8-u
Contextual Info: ASSEMBLY AND INSTALLATION INSTRUCTIONS A4S 20 / 15 / 10 MeterBeam C O R P O R A T I O N 951279 8/98 A4S WARNING THIS ANTENNA IS AN ELECTRICAL CONDUCTOR. CONTACT WITH POWER LINES CAN RESULT IN DEATH, OR SERIOUS INJURY. DO NOT INSTALL THIS ANTENNA WHERE THERE IS ANY POSSIBILITY OF CONTACT WITH OR HIGH VOLTAGE ARCOVER FROM POWER CABLES OR SERVICE DROPS TO BUILDINGS. THE ANTENNA, SUPPORTING MAST AND/OR TOWER