Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    Part Img UC3625QTR datasheet by Texas Instruments

    • UC3625 - Brushless DC Motor Controller 28-PLCC 0 to 70
    • Original
    • Yes
    • Unknown
    • Obsolete
    • EAR99
    • 8542.39.00.01
    • 8542.39.00.00
    • Find it at Findchips.com
    • Always verify details of parts you are evaluating, as these parts are offered as suggestions for what you are looking for and are not guaranteed.

    UC3625QTR datasheet preview

    UC3625QTR Frequently Asked Questions (FAQs)

    • The UC3625QTR is a high-frequency device, and proper layout and placement are crucial to minimize EMI. TI recommends a 4-layer PCB with a solid ground plane, and placing the IC close to the input capacitors and output inductors. Additionally, keep the high-current paths short and away from sensitive analog signals.
    • To ensure stability, make sure to follow the recommended compensation network values and placement. Also, ensure that the output voltage is within the specified range, and the input voltage is within the recommended operating range. Additionally, use a low-ESR output capacitor and a suitable inductor with a high saturation current rating.
    • The UC3625QTR is rated for operation from -40°C to 125°C. However, the maximum ambient temperature range may vary depending on the specific application and thermal design. It's essential to consider the thermal derating and ensure proper heat sinking to maintain a safe operating temperature.
    • Yes, the UC3625QTR can be used in a synchronous rectification configuration. However, it's essential to ensure that the synchronous rectifier is properly synchronized with the UC3625QTR's switching frequency and that the rectifier's voltage rating is sufficient for the output voltage.
    • To troubleshoot issues with the UC3625QTR, start by verifying the input voltage, output voltage, and current sense resistor values. Check for any signs of overheating, and ensure that the PCB layout and component placement are correct. Use an oscilloscope to monitor the switching waveforms and look for any signs of oscillation or instability.
    Price & Stock Powered by Findchips Logo
    Supplyframe Tracking Pixel