Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    Part Img TS5A63157DCKR datasheet by Texas Instruments

    • 12-OHM SPDT ANALOG SWITCH
    • Original
    • Yes
    • Yes
    • Active
    • EAR99
    • 8542.39.00.01
    • 8542.39.00.00
    • Powered by Findchips Logo Findchips
    • Always verify details of parts you are evaluating, as these parts are offered as suggestions for what you are looking for and are not guaranteed.

    TS5A63157DCKR datasheet preview

    TS5A63157DCKR Frequently Asked Questions (FAQs)

    • A good PCB layout for the TS5A63157DCKR involves keeping the analog and digital grounds separate, using a solid ground plane, and placing the device close to the power supply. Additionally, using a thermal pad and vias to dissipate heat and minimizing the length of the input traces can help reduce EMI and thermal issues.
    • The TS5A63157DCKR requires a single 1.8V to 5.5V power supply. It's recommended to power the device with a clean, low-noise power supply, and to sequence the power-on in the following order: VCC, then VIN. Additionally, it's recommended to use a 0.1uF decoupling capacitor between VCC and GND, and a 1uF capacitor between VIN and GND.
    • The TS5A63157DCKR supports data rates up to 480 Mbps and cable lengths up to 3 meters. However, the actual data rate and cable length may vary depending on the specific application and environment.
    • The TS5A63157DCKR can be configured for half-duplex or full-duplex operation by setting the MODE pin high or low, respectively. In half-duplex mode, the device transmits and receives on the same pin, while in full-duplex mode, the device has separate transmit and receive pins.
    • The TS5A63157DCKR has built-in ESD protection diodes on the input pins, which can withstand up to ±2kV of ESD. Additionally, the device has latch-up prevention circuitry to prevent damage from overvoltage or overcurrent conditions.
    Supplyframe Tracking Pixel