TS3A24157DGSR datasheet by Texas Instruments

TS3A24157DGSR Frequently Asked Questions (FAQs)

• What is the recommended PCB layout for the TS3A24157DGSR to minimize signal integrity issues?
  A good PCB layout practice is to keep the signal traces as short as possible, use a solid ground plane, and avoid crossing signal traces over each other. Also, it's recommended to use a 4-layer PCB with a dedicated power plane and a dedicated ground plane.
• How do I ensure the TS3A24157DGSR is properly powered and decoupled?
  The TS3A24157DGSR requires a 1.8V to 3.6V power supply. Ensure that the power supply is clean and stable, and decouple the power pins with 0.1uF and 10uF capacitors. Also, add a 10nF capacitor between the VCC and GND pins to filter out high-frequency noise.
• What is the maximum data rate that the TS3A24157DGSR can support?
  The TS3A24157DGSR can support data rates up to 100 Mbps, but the actual data rate may vary depending on the system design and the quality of the signal transmission lines.
• How do I configure the TS3A24157DGSR for differential or single-ended operation?
  The TS3A24157DGSR can be configured for differential or single-ended operation by setting the MODE pin high or low, respectively. For differential operation, connect the MODE pin to VCC, and for single-ended operation, connect the MODE pin to GND.
• What is the maximum cable length that the TS3A24157DGSR can drive?
  The TS3A24157DGSR can drive cables up to 10 meters long, but the actual cable length may vary depending on the cable quality, signal frequency, and system design.