The recommended layout for the TPS3707-30DGNR involves placing the device close to the power source, using short and wide traces for the power lines, and keeping the sense lines away from the power lines to minimize noise. Additionally, a 10nF capacitor should be placed between the VCC and GND pins to filter out noise.
The correct resistor values for the TPS3707-30DGNR depend on the desired threshold voltage and hysteresis. The datasheet provides a formula to calculate the resistor values based on the desired threshold voltage and hysteresis. It is recommended to use 1% tolerance resistors to ensure accurate threshold voltage and hysteresis.
The maximum voltage that can be applied to the TPS3707-30DGNR is 40V. Exceeding this voltage can damage the device. It is recommended to use a voltage limiter or a voltage regulator to ensure that the voltage does not exceed the maximum rating.
The TPS3707-30DGNR has an internal voltage limiter that prevents the output from exceeding 30V. If the input voltage exceeds 30V, the device will enter an overvoltage condition and the output will be clamped to 30V. The device will recover once the input voltage returns to a safe level.
The TPS3707-30DGNR is rated for operation up to 125°C. However, the device's accuracy and reliability may be affected at high temperatures. It is recommended to derate the device's performance and consider using a heat sink or thermal management system to ensure reliable operation in high-temperature applications.
TPS3707-30DGNR datasheet
by Texas Instruments
Findchips
