TPS2552DBVT datasheet by Texas Instruments

TPS2552DBVT Frequently Asked Questions (FAQs)

• What is the maximum current rating of the TPS2552DBVT?
  The maximum current rating of the TPS2552DBVT is 2.5A, but it can be limited by the thermal performance of the PCB and the ambient temperature.
• How do I ensure the TPS2552DBVT is properly thermally managed?
  To ensure proper thermal management, ensure a good thermal connection between the device and the PCB, use a sufficient copper area for heat dissipation, and consider using a heat sink or thermal pad if necessary.
• What is the purpose of the EN pin, and how do I use it?
  The EN (enable) pin is used to turn the device on and off. To use it, connect the EN pin to a logic-level signal (e.g., from a microcontroller) to enable or disable the device. A logic high (> 2.4V) enables the device, while a logic low (< 0.4V) disables it.
• How do I choose the correct sense resistor value for my application?
  Choose a sense resistor value that provides a voltage drop of 50-100mV at the maximum expected current. This ensures accurate current sensing and minimizes power loss in the sense resistor.
• What is the purpose of the FLT pin, and how do I use it?
  The FLT (fault) pin is an open-drain output that indicates an overcurrent or overtemperature fault. Connect a pull-up resistor to a voltage rail, and monitor the FLT pin to detect faults. The FLT pin is active low, meaning it is pulled low during a fault condition.