Texas Instruments recommends a compact layout with short traces, and placing the device close to the power supply and load to minimize noise and parasitic inductance. A 4-layer PCB with a solid ground plane is also recommended.
Use a low-pass filter or a ferrite bead in series with the output to reduce high-frequency noise. Additionally, ensure good PCB layout practices, such as separating analog and digital grounds, and using a solid ground plane.
The TLC2262IDG4 can drive capacitive loads up to 10nF, but it's recommended to limit the load capacitance to 1nF or less to ensure stability and prevent oscillations.
Ensure the device is properly bypassed with a 10uF ceramic capacitor between VCC and GND, and a 100nF capacitor between the output and GND. Also, use a low-ESR output capacitor and avoid using long output traces.
The recommended input voltage range for the TLC2262IDG4 is 4.5V to 16V, but it can operate down to 3.8V with reduced performance. Operating the device outside of this range may affect its reliability and performance.
TLC2262IDG4 datasheet
by Texas Instruments
