A good PCB layout for the THS6012CDWP involves keeping the input and output traces short and away from each other, using a solid ground plane, and placing decoupling capacitors close to the device. A 4-layer PCB with a dedicated power plane and a dedicated ground plane is recommended.
The choice of gain resistors depends on the desired gain and bandwidth of the amplifier. A higher gain resistor value will result in a higher gain, but may also reduce the bandwidth. TI provides a gain resistor calculator tool to help with the selection.
The maximum power dissipation of the THS6012CDWP is 1.4W. This is calculated based on the maximum junction temperature of 150°C and the thermal resistance of the package.
Yes, the THS6012CDWP can be used as a single-ended amplifier by tying the negative input to ground and using the positive input as the signal input. However, this will reduce the common-mode rejection ratio and may affect the noise performance.
The THS6012CDWP has a built-in low-pass filter that can be used to filter out high-frequency noise. Additionally, external filters such as RC filters or ferrite beads can be used to further reduce noise.