The STR710FZ1H6 can operate from -40°C to 105°C (junction temperature), but the recommended operating temperature range is -20°C to 85°C for optimal performance and reliability.
The STR710FZ1H6 has multiple clock sources, including an internal RC oscillator, an external crystal oscillator, and an external clock source. You can configure the clock source using the Clock Control Register (CKCU) and the Power Management Controller (PMC). Refer to the datasheet and application notes for specific configuration details.
The maximum current consumption of the STR710FZ1H6 depends on the operating frequency, voltage, and peripherals used. According to the datasheet, the maximum current consumption is around 350 mA at 3.3V and 48 MHz. However, this value can be reduced by using power-saving modes and optimizing the system design.
The STR710FZ1H6 has a built-in watchdog timer (WDT) that can be enabled and configured using the Watchdog Timer Control Register (WDTC). You can set the watchdog timer period, enable or disable the watchdog, and configure the reset behavior using the WDTC register. Refer to the datasheet and application notes for specific implementation details.
The STR710FZ1H6's ADC has a 12-bit resolution and can operate at a maximum sampling rate of 1.2 Msps. However, the ADC has some limitations, such as a limited input voltage range (0 to VCC), a maximum input impedance of 10 kΩ, and a conversion time of around 1.2 μs. Additionally, the ADC may require calibration and trimming for optimal performance.
STR710FZ1H6 datasheet
by STMicroelectronics
Findchips
Findchips