The recommended operating voltage range for the ST8024LCDR is 2.7V to 5.5V.
The ST8024LCDR can be configured for I2C or SPI interface by setting the MODE pin high or low, respectively. For I2C, connect MODE to VCC, and for SPI, connect MODE to GND.
The maximum clock frequency supported by the ST8024LCDR is 10 MHz for I2C and 20 MHz for SPI.
The reset pin (RST) on the ST8024LCDR should be pulled high to VCC through a resistor (e.g., 10kΩ) to ensure proper operation. A low signal on RST resets the device.
The VCOM pin on the ST8024LCDR is used to set the common voltage for the LCD display. It should be connected to a voltage divider or a voltage regulator to generate the required voltage.