The recommended operating voltage range for the SN74HC664NT is 2V to 6V, with a typical operating voltage of 5V.
It is recommended to power up the VCC pin before the input signals, and power down the VCC pin after the input signals. This ensures that the device is properly initialized and avoids any potential latch-up or damage.
The maximum frequency of operation for the SN74HC664NT is 25 MHz, although this can vary depending on the specific application and operating conditions.
It is recommended to use a termination resistor (e.g. 33 ohms) at the end of the transmission line to prevent signal reflections and ensure signal integrity.
Yes, the SN74HC664NT can be used in a 3.3V system, but the output voltage will be limited to 3.3V. Additionally, the device may not be able to drive as much current at 3.3V as it can at 5V.
