SN74ALVTH16601DLR datasheet by Texas Instruments

SN74ALVTH16601DLR Frequently Asked Questions (FAQs)

• What is the recommended operating voltage range for the SN74ALVTH16601DLR?
  The recommended operating voltage range for the SN74ALVTH16601DLR is 2.3V to 3.6V, with a typical operating voltage of 3.3V.
• How do I ensure signal integrity when using the SN74ALVTH16601DLR in a high-speed application?
  To ensure signal integrity, use a low-impedance PCB design, keep signal traces short and away from noise sources, and use termination resistors as needed. Additionally, consider using a signal integrity analysis tool to simulate and optimize your design.
• Can I use the SN74ALVTH16601DLR in a 5V system?
  No, the SN74ALVTH16601DLR is not designed to operate at 5V. The maximum recommended operating voltage is 3.6V, and exceeding this voltage can cause damage to the device.
• How do I handle power sequencing when using the SN74ALVTH16601DLR in a system with multiple power rails?
  To ensure proper operation, power up the VCC pin before applying any input signals, and power down the VCC pin after removing all input signals. Additionally, ensure that the power rails are sequenced in a way that prevents any voltage differences between the rails from exceeding the maximum rating of the device.
• What is the maximum clock frequency supported by the SN74ALVTH16601DLR?
  The maximum clock frequency supported by the SN74ALVTH16601DLR is 100 MHz, but this can vary depending on the specific application and operating conditions. Consult the datasheet and application notes for more information.