SN74ALVTH162827VR datasheet by Texas Instruments

SN74ALVTH162827VR Frequently Asked Questions (FAQs)

• What is the recommended operating voltage range for the SN74ALVTH162827VR?
  The recommended operating voltage range for the SN74ALVTH162827VR is 2.3V to 3.6V, with a typical voltage of 3.3V.
• How do I ensure signal integrity when using the SN74ALVTH162827VR in a high-speed application?
  To ensure signal integrity, use a low-impedance PCB design, keep signal traces short and away from noise sources, and use termination resistors as needed. Additionally, consider using a signal integrity analysis tool to simulate and optimize your design.
• Can I use the SN74ALVTH162827VR in a 5V system?
  No, the SN74ALVTH162827VR is not recommended for use in 5V systems. The maximum recommended operating voltage is 3.6V, and exceeding this voltage can cause damage to the device.
• How do I handle power sequencing when using multiple SN74ALVTH162827VR devices in a system?
  To ensure proper operation, power up the devices in a sequence that ensures the output enable (OE) pin is high before the clock (CLK) pin is active. This prevents unwanted output transitions during power-up.
• What is the maximum clock frequency supported by the SN74ALVTH162827VR?
  The maximum clock frequency supported by the SN74ALVTH162827VR is 100 MHz, but this can vary depending on the specific application and operating conditions. Consult the datasheet and application notes for more information.