The maximum operating frequency of the SN74ACT00NSR is typically around 100 MHz, but it can vary depending on the specific application and operating conditions.
The SN74ACT00NSR has a recommended input voltage range of 4.5V to 5.5V, but it can tolerate input voltages as low as 3.5V or as high as 7V for short periods of time. However, operating outside the recommended range may affect the device's performance and reliability.
The power consumption of the SN74ACT00NSR depends on the operating frequency and input voltage. At a frequency of 10 MHz and an input voltage of 5V, the typical power consumption is around 20 mW. However, this can increase to around 100 mW at higher frequencies and input voltages.
Yes, the SN74ACT00NSR can be used in a 3.3V system, but it may not provide the same level of performance as it would at 5V. The device's output voltage levels may not be as high, and the noise margin may be reduced. However, it can still be used in 3.3V systems with proper design and layout considerations.
To ensure signal integrity when using the SN74ACT00NSR, it's essential to follow proper PCB design and layout guidelines, such as using short signal traces, minimizing impedance mismatches, and providing adequate decoupling capacitors. Additionally, consider using series termination resistors to reduce signal reflections and ringing.
SN74ACT00NSR datasheet
by Texas Instruments
