The maximum cable length depends on the specific application and the signal frequency. As a general rule, the maximum cable length for LVDS signals is around 10-15 meters at 100 Mbps. However, it's recommended to consult the TI application note 'LVDS Owner's Manual' (SLMA002) for more detailed information on cable length and signal integrity.
The SN65LVDS34DRG4 has internal 100-ohm differential termination resistors, so no external termination resistors are required. However, it's recommended to add a 0.1-uF capacitor between the VCC and GND pins to filter the power supply and reduce noise.
The power consumption of the SN65LVDS34DRG4 depends on the operating frequency and the load capacitance. According to the datasheet, the typical power consumption is around 15 mA at 100 Mbps with a 100-pF load capacitance. However, it's recommended to consult the datasheet and the TI application notes for more detailed information on power consumption and thermal considerations.
Yes, the SN65LVDS34DRG4 can support high-speed data transmission up to 400 Mbps. However, it's recommended to consult the TI application notes and the datasheet for more detailed information on signal integrity, PCB layout, and termination requirements for high-speed operation.
To ensure signal integrity and reduce EMI, it's recommended to follow good PCB design practices, such as using a solid ground plane, minimizing signal trace lengths, and using shielded cables. Additionally, it's recommended to add EMI filters and shielding to the design, and to consult the TI application notes and the datasheet for more detailed information on signal integrity and EMI reduction.
SN65LVDS34DRG4 datasheet
by Texas Instruments
Findchips
