SN65LBC176D datasheet by Texas Instruments

SN65LBC176D Frequently Asked Questions (FAQs)

• What is the maximum cable length supported by the SN65LBC176D?
  The maximum cable length supported by the SN65LBC176D is dependent on the specific application and the type of cable used. However, as a general guideline, the device can support cable lengths of up to 100 meters at a data rate of 100 Mbps.
• How do I ensure signal integrity and minimize electromagnetic interference (EMI) when using the SN65LBC176D?
  To ensure signal integrity and minimize EMI, it is recommended to use a shielded cable, keep the cable away from noise sources, use a common mode choke, and follow proper PCB layout and grounding techniques.
• What is the recommended termination scheme for the SN65LBC176D?
  The recommended termination scheme for the SN65LBC176D is a 100-ohm differential termination resistor at the receiving end of the cable, and a 50-ohm single-ended termination resistor at the transmitting end.
• How do I handle hot swapping and fault tolerance with the SN65LBC176D?
  The SN65LBC176D has built-in hot swap and fault tolerance capabilities. It can detect and recover from faults, and it also has a hot swap detection circuit that can detect when a device is inserted or removed.
• What is the power consumption of the SN65LBC176D, and how can I reduce power consumption?
  The power consumption of the SN65LBC176D is typically around 150 mW. To reduce power consumption, it is recommended to use the device's low-power mode, reduce the clock frequency, and use a lower voltage supply.