The maximum cable length supported by the SN65HVD1793DR is dependent on the specific application and the type of cable used. However, as a general guideline, the device can support cable lengths of up to 100 meters at a data rate of 100 Mbps.
The SN65HVD1793DR can be configured for half-duplex or full-duplex operation by setting the HDX pin high or low, respectively. When the HDX pin is high, the device operates in half-duplex mode, and when it is low, the device operates in full-duplex mode.
The power consumption of the SN65HVD1793DR depends on the operating mode and the data rate. In typical operating conditions, the device consumes around 150 mA at 3.3 V supply voltage. However, this value can vary depending on the specific application and the data rate.
To implement fault tolerance in a system using the SN65HVD1793DR, you can use redundant transceivers and implement a fault detection mechanism to detect and switch to the redundant transceiver in case of a failure. Additionally, you can use error detection and correction mechanisms, such as checksums and retries, to ensure reliable data transmission.
The SN65HVD1793DR supports data rates of up to 100 Mbps.
SN65HVD1793DR datasheet
by Texas Instruments
Findchips
