The maximum cable length supported by the SN65HVD1050DRG4 is dependent on the specific application and the type of cable used. However, as a general guideline, the device can support cable lengths of up to 100 meters at a data rate of 1 Mbps.
To ensure signal integrity and minimize EMI, it is recommended to use a shielded cable, keep the cable length as short as possible, and use a common-mode choke or ferrite bead to filter out high-frequency noise. Additionally, proper PCB layout and grounding techniques should be followed to minimize radiation and coupling.
The recommended termination scheme for the SN65HVD1050DRG4 is a 120-ohm differential termination resistor at the receiving end of the bus. This helps to match the impedance of the cable and reduce reflections.
Yes, the SN65HVD1050DRG4 can be used in a multi-point configuration, but it requires the use of a repeater or a hub to connect multiple nodes. The device can support up to 32 nodes on a single bus.
The SN65HVD1050DRG4 supports data rates of up to 1 Mbps, making it suitable for a wide range of industrial and automotive applications.
SN65HVD1050DRG4 datasheet
by Texas Instruments
