The maximum operating frequency of the SN54HC20J is 25 MHz, but it can vary depending on the specific application and operating conditions.
The output enable (OE) pin is active-low, meaning that the outputs are enabled when OE is low and disabled when OE is high. You should connect OE to a logic low signal to enable the outputs, and to a logic high signal to disable them.
Texas Instruments recommends using a 0.1 μF capacitor and a 1 kΩ resistor in series between the VCC pin and the GND pin to create a POR circuit. This ensures that the device powers up in a known state.
To ensure that the SN54HC20J operates within its recommended operating conditions, you should ensure that the supply voltage (VCC) is within the range of 2 V to 6 V, and that the operating temperature is within the range of -40°C to 125°C.
The maximum current that the SN54HC20J can sink or source is 25 mA per output pin, with a total current limit of 100 mA for all outputs combined.