P82B96TD datasheet by NXP Semiconductors

P82B96TD Frequently Asked Questions (FAQs)

• What is the recommended operating voltage range for the P82B96TD?
  The recommended operating voltage range for the P82B96TD is 3.0 V to 5.5 V.
• How do I ensure reliable data transmission over the I2C bus?
  To ensure reliable data transmission over the I2C bus, make sure to use a pull-up resistor on the SCL and SDA lines, and ensure that the clock frequency is within the recommended range of 10 kHz to 400 kHz.
• What is the maximum current that the P82B96TD can sink or source?
  The P82B96TD can sink or source up to 20 mA of current per I/O pin.
• How do I configure the P82B96TD for I2C slave mode?
  To configure the P82B96TD for I2C slave mode, set the EN pin high, and connect the SCL and SDA pins to the I2C bus. Then, configure the device address using the A0, A1, and A2 pins.
• What is the purpose of the reset pin (RST) on the P82B96TD?
  The reset pin (RST) is used to reset the device to its default state. When the RST pin is pulled low, the device resets and all registers are cleared.