The maximum operating temperature range for the MSP430F2617TZQWR is -40°C to 85°C, as specified in the datasheet. However, it's essential to note that the device can operate at temperatures beyond this range, but with reduced performance and reliability.
To configure the MSP430F2617TZQWR for low-power operation, you can use the Power Management Module (PMM) to control the power modes. The PMM allows you to select from various power modes, such as Active, LPM0, LPM1, LPM2, LPM3, and LPM4, each with decreasing power consumption. You can also use the Dynamic Voltage Scaling (DVS) feature to adjust the voltage and frequency of the device based on the application's requirements.
The maximum clock frequency for the MSP430F2617TZQWR is 16 MHz, which can be achieved using an external crystal oscillator or a high-frequency internal oscillator. However, the device can also operate at lower frequencies, such as 1 MHz or 32768 Hz, to reduce power consumption.
The USCI on the MSP430F2617TZQWR is a flexible serial communication interface that can be configured as a UART, SPI, or I2C interface. To use the USCI, you need to configure the interface using the USCI registers, select the desired communication mode, and set the baud rate and other parameters according to your application's requirements.
The JTAG (Joint Test Action Group) interface on the MSP430F2617TZQWR is a debugging interface that allows you to debug and program the device using a JTAG debugger or emulator. The JTAG interface provides access to the device's internal registers, memory, and peripherals, enabling you to debug and test your application.
MSP430F2617TZQWR datasheet
by Texas Instruments
