MSP430F2272IYFFT datasheet by Texas Instruments

MSP430F2272IYFFT Frequently Asked Questions (FAQs)

• What is the recommended crystal oscillator frequency for the MSP430F2272IYFFT?
  The recommended crystal oscillator frequency for the MSP430F2272IYFFT is between 32.768 kHz and 16 MHz, with a typical frequency of 4 MHz or 8 MHz.
• How do I configure the MSP430F2272IYFFT for low-power operation?
  To configure the MSP430F2272IYFFT for low-power operation, set the CPU to low-power mode (LPM3 or LPM4) using the _BIS_SR(LPMx_bits) instruction, and disable unnecessary peripherals and clocks. Additionally, use the Power Manager (PMM) module to control the voltage regulator and reduce power consumption.
• What is the maximum current consumption of the MSP430F2272IYFFT?
  The maximum current consumption of the MSP430F2272IYFFT depends on the operating frequency, voltage, and peripherals used. According to the datasheet, the maximum current consumption is approximately 2.1 mA at 1 MHz, 2.2V, and 25°C, with all peripherals enabled.
• How do I use the MSP430F2272IYFFT's built-in temperature sensor?
  The MSP430F2272IYFFT has a built-in temperature sensor that can be accessed through the Temperature Sensor (TS) module. To use the temperature sensor, enable the TS module, configure the sensor gain and offset, and read the temperature data from the TS register.
• Can I use the MSP430F2272IYFFT with an external flash memory?
  Yes, the MSP430F2272IYFFT can be used with an external flash memory. The device has a 16-bit external memory interface that can be used to connect to external flash memory devices. However, the external memory interface is only available on certain packages (e.g., LQFP64) and requires additional configuration and programming.