MC9S08DZ96CLL datasheet by Freescale Semiconductor

MC9S08DZ96CLL Frequently Asked Questions (FAQs)

• What is the maximum clock frequency that can be used with the internal oscillator?
  The maximum clock frequency that can be used with the internal oscillator is 20 MHz, but it's recommended to use a crystal oscillator for frequencies above 16 MHz for better stability and accuracy.
• How do I configure the watchdog timer to reset the MCU in case of a fault?
  To configure the watchdog timer, set the WDT_CVAL register to the desired timeout value, enable the watchdog timer by setting the WDT_EN bit in the WDT_CS1 register, and make sure to periodically refresh the watchdog timer by writing a new value to the WDT_CVAL register before the timeout expires.
• Can I use the MCU's internal voltage regulator to power external components?
  No, the internal voltage regulator is only intended to power the MCU itself and should not be used to power external components. Use an external voltage regulator or power supply to power external components.
• How do I implement a low-power mode to reduce power consumption?
  To implement a low-power mode, use the STOP or WAIT instructions to put the MCU into a low-power state. You can also use the Bit Manipulation (BM) module to control the power modes of individual peripherals. Additionally, consider using the MCU's built-in low-power modes, such as the Very Low Power (VLP) mode.
• What is the maximum current that can be sourced or sunk by the GPIO pins?
  The maximum current that can be sourced or sunk by the GPIO pins is 25 mA per pin, but it's recommended to limit the current to 10 mA per pin to ensure reliable operation and prevent overheating.