A 4-layer PCB with a solid ground plane and a separate power plane is recommended. Keep the analog and digital grounds separate and connect them at a single point. Use a 10uF capacitor between VCC and GND, and a 1uF capacitor between AVCC and AGND.
Apply power to VCC and AVCC simultaneously, with VCC rising first. Ensure the power supply is stable and within the recommended voltage range. Configure the device by writing to the control registers through the I2C interface.
The I2C interface on the MAX9180EXT-T supports data transfer rates up to 400 kHz in Fast Mode and 1 MHz in High-Speed Mode.
Use a thermal pad on the PCB to dissipate heat. Ensure good airflow around the device, and consider using a heat sink if the device is expected to operate in high-temperature environments.
Use ESD protection devices such as TVS diodes or ESD arrays on the I2C bus lines and other sensitive inputs to protect the device from electrostatic discharge.
MAX9180EXT-T datasheet
by Maxim Integrated Products
