The MAX6360LSUT+T is a sensitive device and requires careful layout and placement to ensure optimal performance. It is recommended to place the device close to the battery, use short traces, and avoid routing high-frequency signals near the device. Additionally, a solid ground plane and a decoupling capacitor (e.g., 10nF) between VCC and GND are recommended.
The RST output is an open-drain output and requires an external pull-up resistor to a voltage rail (e.g., VCC). During power-up, the RST output will be low until the internal voltage regulator is stable and the device is fully powered up. During power-down, the RST output will go low before the device shuts down. It is recommended to use a pull-up resistor value between 1kΩ to 10kΩ to ensure proper operation.
The maximum allowed voltage on the input pins (VIN, VBAT) during power-down or shutdown mode is 6V. Exceeding this voltage may cause damage to the device. It is recommended to ensure that the input voltage is within the specified range during all operating modes.
To ensure proper reset during power-up or brownout conditions, it is recommended to use a power-on reset (POR) circuit or a voltage supervisor with a reset timeout period of at least 100ms. This will ensure that the device is properly reset and initialized during power-up or brownout conditions.
The recommended operating temperature range for the MAX6360LSUT+T is -40°C to +85°C. Operating the device outside this range may affect its performance, reliability, or lifespan.
MAX6360LSUT+T datasheet
by Maxim Integrated Products
