The recommended PCB layout for the MAX4305ESA+ is to keep the input and output traces as short as possible, and to use a solid ground plane to reduce noise and EMI. Additionally, it's recommended to place a 0.1uF bypass capacitor between the VCC pin and GND pin, and to use a 1uF capacitor between the VIN pin and GND pin.
To ensure the MAX4305ESA+ is stable and doesn't oscillate, make sure to follow the recommended PCB layout, use a stable input voltage, and ensure that the output capacitor is properly sized. Additionally, it's recommended to add a small resistor (e.g. 10ohm) in series with the output capacitor to prevent oscillation.
The maximum input voltage that the MAX4305ESA+ can handle is 5.5V. Exceeding this voltage may damage the device.
The MAX4305ESA+ is rated for operation up to 125°C. However, it's recommended to derate the output current and voltage at high temperatures to ensure reliable operation. Consult the datasheet for more information on temperature derating.
The output voltage of the MAX4305ESA+ can be calculated using the following formula: VOUT = (VIN x (R1/R2)) + VREF, where R1 and R2 are the resistors used in the feedback network, and VREF is the internal reference voltage (typically 1.25V).
MAX4305ESA+ datasheet
by Maxim Integrated Products
