Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    Part Img MAX11800ETC+ datasheet by Maxim Integrated Products

    • Data Acquisition - Touch Screen Controllers, Integrated Circuits (ICs), IC CTRLR TOUCH-SCREEN 12-TQFN
    • Original
    • Yes
    • Yes
    • Transferred
    • EAR99
    • 8542.31.00.01
    • 8542.31.00.00
    • Powered by Findchips Logo Findchips

    MAX11800ETC+ datasheet preview

    MAX11800ETC+ Frequently Asked Questions (FAQs)

    • The recommended PCB layout for the MAX11800ETC+ is to use a 4-layer board with a solid ground plane, and to keep the analog and digital signals separate. Additionally, it's recommended to use a low-ESR capacitor for the VCC pin and to decouple the VCC pin with a 0.1uF capacitor.
    • To optimize the performance of the MAX11800ETC+ in noisy environments, it's recommended to use a shielded cable for the analog input, to keep the analog input traces short and away from digital signals, and to use a common-mode filter or a differential amplifier to reject common-mode noise.
    • The maximum sampling rate that can be achieved with the MAX11800ETC+ is 1.5Msps, but this can be limited by the system's clock frequency, the analog input bandwidth, and the digital output data rate.
    • The MAX11800ETC+ does not require calibration, as it has an internal calibration circuit that sets the gain and offset of the ADC. However, it's recommended to perform a system-level calibration to account for any external component tolerances and PCB layout variations.
    • The power consumption of the MAX11800ETC+ depends on the operating mode and the clock frequency. In normal operation, the power consumption is typically around 15mW, but it can be reduced to around 1mW in shutdown mode.
    Supplyframe Tracking Pixel