Texas Instruments provides a recommended PCB layout in the datasheet, but it's also recommended to follow general high-speed PCB design guidelines, such as using a solid ground plane, minimizing trace lengths, and using impedance-controlled traces.
The LMH0356SQE-40/NOPB requires a single 3.3V power supply, and it's recommended to use a low-ESR capacitor (e.g., 0.1uF) for power supply decoupling. Additionally, a 10uF capacitor can be used for bulk decoupling.
The maximum cable length supported by the LMH0356SQE-40/NOPB depends on the specific application and the type of cable used. However, as a general guideline, the device can support cable lengths up to 10 meters at data rates up to 3.125 Gbps.
The LMH0356SQE-40/NOPB is a programmable device, and the data rate can be configured using the SPI interface. The device supports data rates from 100 Mbps to 3.125 Gbps, and the specific configuration depends on the application requirements.
The typical power consumption of the LMH0356SQE-40/NOPB is around 250mW at 3.3V and 3.125 Gbps data rate. However, the actual power consumption may vary depending on the specific application and operating conditions.
LMH0356SQE-40/NOPB datasheet
by Texas Instruments
