LM2664M6X/NOPB datasheet by Texas Instruments

LM2664M6X/NOPB Frequently Asked Questions (FAQs)

• What is the maximum input voltage that can be applied to the LM2664M6X/NOPB?
  The maximum input voltage that can be applied to the LM2664M6X/NOPB is 15V. Exceeding this voltage may damage the device.
• How do I ensure stability of the output voltage in the LM2664M6X/NOPB?
  To ensure stability of the output voltage, it is recommended to use a minimum output capacitance of 10uF with an ESR of 1 ohm or less, and to place the capacitor as close to the output pin as possible.
• What is the maximum output current that the LM2664M6X/NOPB can deliver?
  The maximum output current that the LM2664M6X/NOPB can deliver is 3A. Exceeding this current may cause the device to overheat or shut down.
• How do I adjust the output voltage of the LM2664M6X/NOPB?
  The output voltage of the LM2664M6X/NOPB can be adjusted by using a resistive divider network between the output pin and the adjust pin. The ratio of the resistors determines the output voltage.
• What is the purpose of the enable pin on the LM2664M6X/NOPB?
  The enable pin is used to turn the device on or off. When the enable pin is pulled low, the device is in shutdown mode and consumes minimal power. When the enable pin is pulled high, the device is enabled and operates normally.