The recommended PCB layout for the HDSP-2113 involves placing the device near the LCD panel, using a solid ground plane, and minimizing the length of the clock signal traces. A 4-layer PCB with a dedicated ground plane is recommended.
To optimize display settings, adjust the clock frequency, pixel clock polarity, and data enable timing to match the LCD panel's requirements. Also, ensure the display's horizontal and vertical sync signals are properly aligned.
The maximum cable length supported by the HDSP-2113 is approximately 30 cm (12 inches) for the RGB interface and 10 cm (4 inches) for the clock signal. However, this may vary depending on the specific application and cable quality.
To troubleshoot display issues, check the clock signal frequency, pixel clock polarity, and data enable timing. Verify that the display's horizontal and vertical sync signals are properly aligned. Also, check for signal integrity issues, such as signal attenuation or noise, and ensure the display is properly configured.
While the HDSP-2113 is designed to work with standard LCD panels, it may be possible to use it with non-standard panels. However, this may require custom configuration and testing to ensure compatibility. It's recommended to consult with Broadcom Limited or a qualified engineer for assistance.
