The recommended power-on sequence is to apply power to the module, then wait for at least 100ms before applying the reset signal. This allows the internal voltage regulators to stabilize before the module is reset.
To configure the GOLDELOX module for use with a capacitive touchscreen, you need to set the touchscreen mode to 'Capacitive' in the module's configuration registers. You may also need to adjust the touchscreen calibration settings to optimize performance.
The maximum current draw of the GOLDELOX module depends on the specific configuration and operating mode. However, the typical current draw is around 200mA, with a maximum current draw of up to 500mA during peak usage.
Yes, the GOLDELOX module can be used with a custom LCD display, but you may need to modify the display's pinout and configuration to match the module's requirements. You may also need to write custom display drivers to support your specific display.
The firmware on the GOLDELOX module can be updated using the 4D Systems' Workshop4 IDE software. You can download the latest firmware from the 4D Systems website and follow the instructions provided in the Workshop4 user manual.
GOLDELOX datasheet
by 4D Systems
