A 4-layer PCB with a solid ground plane and a separate power plane is recommended. Keep the analog and digital grounds separate and connect them at a single point. Use a low-ESR capacitor for power decoupling.
Use a high-quality, low-ESR capacitor (e.g., 10uF) for power decoupling, and place it as close to the device as possible. Ensure the power supply is clean and regulated, with minimal noise and ripple.
The recommended clock frequency is between 10MHz to 40MHz. However, the device can operate up to 50MHz, but with reduced performance and increased power consumption.
The DS0026CMM outputs 16-bit data in two's complement format. Ensure your system can handle this format, or use an external converter if necessary. Also, be aware of the output data rate, which is dependent on the clock frequency.
The typical power consumption of the DS0026CMM is around 15mA at 3.3V supply voltage, but this can vary depending on the clock frequency, output load, and other factors.