Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    Part Img CD74HCT112E datasheet by Texas Instruments

    • Dual J-K Flip-Flop with Set and Reset Negative-Edge Trigger
    • Original
    • Yes
    • Yes
    • Active
    • EAR99
    • 8542.39.00.01
    • 8542.39.00.00
    • Powered by Findchips Logo Findchips

    CD74HCT112E datasheet preview

    CD74HCT112E Frequently Asked Questions (FAQs)

    • The recommended operating voltage range for CD74HCT112E is 4.5V to 5.5V, although it can operate from 4.5V to 6V with reduced performance.
    • To ensure signal integrity, use a low-impedance PCB layout, keep signal traces short, and use termination resistors or capacitors as needed to minimize reflections and ringing.
    • While CD74HCT112E is specified for 5V operation, it can be used in 3.3V systems with some limitations. However, the output voltage levels may not meet the required specifications, and the device may not function correctly.
    • To avoid latch-up or damage, ensure that the power supplies are sequenced such that the VCC pin is powered up before the input signals, and the input signals are stable before the VCC pin is powered down.
    • The maximum clock frequency that CD74HCT112E can handle is typically around 30-40 MHz, although this can vary depending on the specific application and operating conditions.
    Supplyframe Tracking Pixel