CD74AC10M96 datasheet by Texas Instruments

CD74AC10M96 Frequently Asked Questions (FAQs)

• What is the maximum frequency of operation for the CD74AC10M96?
  The maximum frequency of operation for the CD74AC10M96 is typically around 100 MHz, but it can vary depending on the specific application, supply voltage, and load conditions.
• How do I ensure proper termination for the CD74AC10M96?
  To ensure proper termination, use a 50-ohm termination resistor between the output and VCC, and a 50-ohm termination resistor between the output and GND. This will help to reduce signal reflections and improve signal integrity.
• What is the recommended power-on sequence for the CD74AC10M96?
  The recommended power-on sequence is to apply VCC before applying any input signals. This helps to prevent unwanted output states and ensures proper device operation.
• Can I use the CD74AC10M96 in a 3.3V system?
  Yes, the CD74AC10M96 can operate with a supply voltage as low as 2.0V, making it suitable for 3.3V systems. However, the output voltage swing may be reduced at lower supply voltages.
• How do I handle the output enable (OE) pin?
  The output enable (OE) pin is active-low, meaning that the output is enabled when OE is low (connected to GND) and disabled when OE is high (connected to VCC). Use a pull-up resistor to ensure the OE pin is properly biased.