ADS1243IPWRG4 datasheet by Texas Instruments

ADS1243IPWRG4 Frequently Asked Questions (FAQs)

• What is the recommended layout and placement for the ADS1243IPWRG4?
  Texas Instruments recommends a 4-layer PCB with a solid ground plane, and placing the device close to the analog signal sources to minimize noise. Additionally, it's recommended to keep the analog and digital grounds separate and connect them at a single point.
• How do I optimize the performance of the ADS1243IPWRG4 in noisy environments?
  To optimize performance in noisy environments, use a low-pass filter on the analog input, use a shielded cable for the analog input, and consider using a common-mode filter. Additionally, ensure that the device is properly grounded and decoupled.
• What is the maximum sampling rate that can be achieved with the ADS1243IPWRG4?
  The maximum sampling rate of the ADS1243IPWRG4 is 2000 samples per second (SPS) for a single channel, and 1000 SPS for multiple channels. However, the actual sampling rate may be limited by the system's clock frequency and the device's settling time.
• How do I calibrate the ADS1243IPWRG4 for optimal performance?
  The ADS1243IPWRG4 has an internal calibration mechanism that can be initiated through the CAL pin. The device can also be calibrated using an external calibration signal. It's recommended to perform calibration after power-up and after any changes to the system's operating conditions.
• What is the power consumption of the ADS1243IPWRG4, and how can I reduce it?
  The power consumption of the ADS1243IPWRG4 is typically around 15mW. To reduce power consumption, consider using the device's power-down mode, reducing the clock frequency, and optimizing the system's power supply.